Let me tell you what I have been doing off and on for the last couple of months…
Way back, way, way back in the beginning of December, I started a Craftsy course, “Sewing Designer Jeans” with Angela Wolf. I enjoyed the course and was excited to start my own jeans. I had in my pattern stash my Vogue V2948 pants pattern, which I did my pants fitting course with, and my Vogue V8774 jeans pattern. I just couldn’t not use the Vogue pants pattern, since my Pants Fitting Shell was so comfortable, but I would have to take the pockets and the fly front from my other Vogue pattern, V8774.
I had purchased my supplies previously, with plans to make my own jeans some day: #220 grit sandpaper and a handheld sander for “distressing”, zipper, Jeans buttons and rivets, Denim and topstitching sewing machine needles, and topstitching and regular threads in a “jean yellow” and a white.
I picked two fabrics out of my stash – a blue denim 96% cotton/4% lycra and a black denim of unknown fibres. Now I have learned that cotton distresses better than polyester, so the black denim obviously had some polyester in it.
Seriously, I literally counted how many “rubs” I was giving each fabric just to see the outcome. It took six times as much to get any visible results on the polyester blend and this is the best result I got.
Oh but the cotton/lycra blue denim distressed so well!
Did I start sewing then? No … then I tested my topstitching sewing needle and thread and stitch length with my denim fabrics. I used my 1/4″ foot and my blind hem foot to make the stitching line straight and practiced with different stitch lengths. I liked #4 length on my sewing machine.
On the right was a #3 stitch length (not long enough) and on the left was a #4 stitch length (just right!). I made a note of the stitch length I liked because I knew once I started I would forget what it was!
Looking good!
I also tried out some different decorative stitches on my sewing machine to create a design for my jeans and I made note of which ones I was going to use.
Now I was ready for assembling the patch pockets. I used a fusible interfacing first on all 4 pocket pieces and then ironed the tops of the pockets down 5/8″.
Then I sewed the tops of the pocket flaps down along the short 5/8″ seam allowances and carefully turned them the right way out. More ironing – all along the tops and edges at 5/8″.
Now I hear some sewists use fabric glue too when assembling patch pockets, but I prefer to assemble them with a bit of sewing to secure the folded top edge and a lot of ironing. I’m pretty happy with the result and I do love the distressing! Too bad the black denim doesn’t take to it as well as the blue denim.
More fun, designing the stitching for my patch pockets and choosing which stitches I would use. I put my ideas on paper first and then made a template for drawing my curved lines with my new Chaco Liner.
I placed, marked and measured many times where I wanted my patch pockets on my jeans, just to be sure, and here is the finished result.
This was a lot of fun! I almost wish I could make more jeans pockets, but I better move on to the next steps – back centre seam (flat felled!) and the front pockets and front centre seam. I’ll post about those steps when I get them completed.
In the meantime, Happy Sewing!
Leave a Reply to Linda of Nice dress! Thanks, I made it!! Cancel reply