Sewing Challenges: #So50Visible and #BGchallenge

@sewover50 has been running the #So50Visible Challenge on Instagram and I wasn’t too sure if I’d make their deadline of March 15th! And what do you know… I did! And not only did I, but I found out that I could also enter the #BGchallenge (Breaking Ground Challenge)!

The aim of #So50Visible is to make a pattern from a pattern maker who has models over the age of 50! How many of those do you see day to day? I was lucky to find this collection!

The aim of the #BGchallenge was to make something from a pattern maker you haven’t used before! And what did I make from a pattern maker I haven’t used before who uses models over 50? The Tuesday Stitches Citrus Leggings, of course! You can link to their pattern here if you’d like.

The sewing of this pattern went really well and the finished leggings feel so good – to be honest the first pair of leggings I have EVER worn! And I am going to make and wear MORE!

Yes I had to print out the PDF pattern and glue it together. Some sewists download the PDF pattern onto a flash drive and take it to a printer to have it printed off on large paper for cutting out. Unfortunately the nearest print shop to me is 35 minutes away … who can wait that long … so Sophie and Simon and I just cut and glued ourselves happily into the night!

I had two meters of the BEST fabric. I should have taken a photo of the bolt end so I could remember it’s content. I remember it had a spandex content though with a good four way stretch, as recommended by Tuesday Stitches, and it was quite thick compared to some of the stretch knit fabrics I see. I chose to do view C without the gathers, so that I could squeeze TWO pairs on to my fabric, so it was easy to sew all the seams – skipping the gathers. Maybe I’ll make a pair with gathers, view A or B, next time. I used a narrow long zig zag stitch and didn’t have much of a problem except for when I sewed through a couple of thicknesses for the hems.

Tuesday Stitches has a tutorial for a hidden wide waistband elastic here, which I used and liked. First though, I put the leggings on inside out and measured where the waistband elastic should go.

Fitting for the wide waistband elastic.
I made extra sure to centre my elastic on my front and back seams.
Using my long zig zag to attach my elastic.
As an extra precaution I stitched the elastic down all along the waistline.

There are three seams on each leg that you can use for fitting. Let a bit out here, take a bit in there! I think I might let out the seam along my calves just a bit, that seems to be the only place I am not right on with the fit. Big calves! Otherwise, these are really really comfortable!

Now excuse me while I go over to Instagram and submit my entry to the #So50Visible and #BGchallenge and tell them what a wonderful job they are doing running these challenges. I think I’ll go tell Tuesday Stitches how much I love their Citrus Leggings pattern too!

Have you made yourself a pair of leggings yet? If so, which pattern did you use?

Happy Sewing!

STASH BUSTING WITH THIS PROJECT? Well, no change there … still 131.2 meters left … I bought two meters so I could make these Citrus Leggings and I used it all up!


It’s finally finished!

Part of my #makenine 2019 Challenge is this pattern, Islander Sewing Systems Jacket Express. I have made this pattern before here. This time though, I was determined not to make the same mistake again. (Putting the buttons and buttonholes on the wrong sides – seriously!!!!)

If you would like to read and see the photos for this jacket from the beginning, start here and then here. I’m so happy to be finished and so happy with my new Jeans jacket. I only had a few steps left – Jeans buttons and buttonholes – but it seemed like forever to get a chance to sit down at my machine and sew!

First off, I asked on Instagram which Jeans button should I use?

The majority answer was the darker ones on the right! Thank you fellow sewists!

Next step was the buttonholes, six of them. I did a practice on a scrap piece of fabric and when it turned out well I continued with the four on the front and the two cuffs. I didn’t use my topstitching thread for these buttonholes – just a matching polyester thread. My Janome buttonhole foot did a fine job. I always start with the cuffs because they are always buttoned up and no one really notices them. Then as my confidence grows, I work my way up to the top buttonhole last – because that one is usually always undone. (Yes, that is a Minion bandaid. That’s how I roll!)

When I headed for my sewing table this morning, what did I see? It’s no wonder my sewing is covered with cat hair!

Sophie in the Sun

So after I found a new spot for Sophie to nap and brushed the cat hair off of my jacket, I took a good look at my jacket. It still needed something… not sure what… but as you can see, my inspiration photo wasn’t just a really cool jacket with really cool fabric, there had to be something more too!

My Inspiration – the young lady on the left

So I took a visit to my Pinterest boards and rediscovered these …

That put me on a hunt through my fabric stash for some embroidery or lace. I didn’t have anything in black or red, but I did have lots of white lace (an old white “lace” tablecloth).

Cutting the flowered sections out of the tablecloth was easy. I then tried a couple of different sewing machine feet and settled for my free motion quilting foot. I was happy to have a “needle down” setting on my sewing machine so that every time I stopped sewing not only did my needle stay down, but my free motion quilting foot did too – holding the lace to my fabric. It took a little getting used to to sew with this foot. Every time the needle came up the foot came up too so that I could maneuver the fabric to sew around the outline of the flowers. I probably wasn’t using the proper technique, but I was successful in sewing on my lace flowers. And it was fun!

Next came attaching the Jeans buttons. I’ve done this before and I rather like tapping the buttons together with my little hammer. I always first practice attaching a couple of Jeans buttons on scrap fabric until I am comfortable with the process. I also always let Mr. Green Thumb know what I’m up to because if he hears hammering he always runs to see what’s being built!

My awl made a neat hole for the Jeans button post to easily go through the layers of fabric.

Place the Jeans button post on the flat bottom holder and the button will be held on the top holder. I had to remove the little piece from the top holder as this Jeans Button style didn’t have a hole it would fit into!


Time to sandwich it all together. Jeans button holder, Jeans button post sitting on the holder and pushed through the hole made by my awl, Jeans button on top and holder placed carefully down on it.

Three little taps with my little hammer.

Jeans button on and not bent! Practice done, let’s tackle the real thing!

I was outside in my sweater, sitting on the concrete steps, hammering on these Jeans buttons, and I just about froze … even though the sun was high in the clear blue sky. Luckily I only had 6 Jeans buttons to attach. I was quite surprised though, when I went out again a little while later to take photos of my new Jean Jacket, how warm my jacket kept me! It is quite heavy for denim. I could still see the odd patch of snow here and there in the garden and the pond was still frozen, but I should have been wearing sunglasses!

This pattern is definitely not for a fitted jacket, and some might want to make a size smaller, but I find it really comfortable and roomy enough to wear a sweater or hoodie underneath.

I took some inside shots too, since everything outside seemed to have a glare! Every time I see the back of the jacket I am reminded of when I constantly told our kids I have “eyes in the back of my head”. Well now I sort of do and better yet, they seem to follow your every move!

Next project? I’ve got my pattern picked out and my fabric chosen for the #sewover50 #so50visible Challenge on Instagram! Are you joining this Challenge? Deadline is March 15th!

Happy Sewing!

STASH BUSTING WITH THIS PROJECT? 3 meters. I still have enough of the print to happily make a bag or two and I still have enough of the black denim for a pair of jeans – already cut out! Now that makes 131.2 meters left in my fabric stash!

2019 sewing plans!

Yes, I know, January is almost over, but this year I have actually done some PRE-PLANNING and this year I plan on finishing:

MY UFO’S:

I know, like everyone, I still have a few UFO’s to finish – a top for my sister, a half made dress for myself, a pair of dress pants and another Sewaholic Hollyburn skirt.

But I’ve also sorted out a few projects I would like to tackle!

DESIGNIN’ DECEMBER 2019:

Of course all year I will be looking for my Designin’ December 2019 inspiration.  I’ll be watching for your inspiration too!

@corrineapplybemakes already has her Designer me-made Copy finished and posted on IG!

There’s no rush, take your time, you’ve got all year to think about it (almost!).  If you would like more details about the DESIGNIN’ DECEMBER challenge take a look at this post here.

ROSIE© BAGS and other such projects:

I’ve made two Rosie© Bags so far this year, one for my sister, @JCVArtStudio, and one for me!!!

I have a 2 meter piece of fabric with a large Parisienne print so I isolated different scenes of the large print and let my sister decide which scene she wanted to use for her Rosie© bag …

… and which scene did she chose?

Next I finished my Rosie© bag.  I used fabrics from the box of upholstery fabric my sister gave me.

I’ve got one more Rosie bag cut out, I’ll get to it … sometime this year!

#magamsewalong

Over on Instagram there are a few Sewing Challenges I love. One is #magamsewalong. @sarahlizsewstyle organizes and inspires us to sew every month … she doesn’t have an easy task! I think my yearly theme is going to be “stash busting”. Hopefully I’ll have time for a few of the monthly themes too.

#makenine2019 INSPIRATION:

Another Instagram Sewing Challenge. I TRIED the #makenine2017 Challenge.  I picked my nine patterns to make during the year. I don’t think I got half way through them!  Now there is the option of choosing to make nine different garments (sewn or knitted or?) instead of picking specific patterns, so this Challenge has my interest.

Part of my inspiration for this Challenge was this meme I found on Facebook.  I can’t find the creator though, any ideas?

I seriously want to be the lady on the left … she’s my Inspiration … she’s just so cool … laid back … I love her.  I would even love to have her hair for a few days!

So here’s my #makenine2019.  

A Jean Jacket similar to the one my Inspiration (above) is wearing, not leather though. My Jean Jacket pattern is by Islander Sewing Systems. I’ve made one before here and I loved the pattern, the instructions and her methods.  This time I’ll put the buttons on the right side though! LOL

Skinny Jeans like my Inspiration.  

A Tunic top sort of like my Inspiration – I don’t want a long one, like her dress length.

Then a hoodie, casual pants and a top.  

And still left from last year’s “sewing to do” list … a bra and granny panties.  

Last, a dress of some sort!

Does anyone know of a on-line shop where I can purchase a complete kit for making a bra – proper fabric, elastic, whatever is needed?  Until I am familiar with what materials and supplies are needed, I would prefer someone just sell me a “kit”, preferably in Canada?

I found 3.5 meters of denim in my stash that I might be able to squeeze a pair of Jeans and a Jacket out of! I also found this embroidered pocket.  I was given this by a sewing blogger friend long ago and I was keeping it for something special.

Well I finally decided what “something special” is … some sort of little coin purse, wallet front or card purse.  I’ll figure something out. In the meantime, I’ve drawn chalk lines all over this and trimmed it down and I am drawing up pattern ideas.

What Challenges are you planning to do this month, next month, this year?

Happy Sewing!

STASH BUSTING WITH THIS PROJECT?  Nothing yet!  Still 130.2 meters left in the fabric stash.